Table of Contents
Advertisement
CP-X270W
Before Replacing the LCD / Lens Prism
You should not replace separately the parts of the liquid crystal LCD / Lens Prism because it works properly only
when used together. Therefore, regarding these parts, you can either replace part , LCD / Lens Prism Ass'y, or send
the whole unit LCD / Lens Prism Ass'y back to Hitachi, where we will replace the malfunctioning part, recondition the
device and send it back to you. In that case please contact our distributor.
DISTRIBUTOR
Air Filter Maintenance
The air filter should be cleaned as described below at intervals of approximately 100 hours.
1. Switch the projector power supply OFF, and remove the power cord from the power outlet.
2. Clean the air filter with a vacuum cleaner.
CAUTION
Switch power OFF and remove the power cord from the power outlet before beginning
maintenance work. Please read the separate "SAFETY INSTRUCTIONS" thoroughly to ensure that
maintenance is performed correctly.
Replace the air filter if contamination cannot be removed, or if it is damaged. Contact your dealer
in such case.(Option Air filter : MU01381)
Do not use the equipment with the air filter removed.
When the air filter is clogged with dust etc. the CHECK AIR FLOW message appears on the
screen and the power supply is switched OFF automatically to prevent the temperature rising
inside the projector.
Do not disassemble the
unit because replacement
of separate parts is not
possible.
For repairs of the product,
please contact our
distributor.
Return
-- 22 --
HITACHI
Replacement of G Panel
G Panel
Reconditioning
Advertisement
Table of Contents
