Table of Contents
Advertisement
4. Press and release the button on the original
remote control every other second until the
indicator lamp has changed from flashing
yellow once per second to either flashing
green 10 times per second or illuminating in
a constant green glow.
5. Depress the programmed HomeLink
and check the indicator lamp.
> Constant green glow: If the indicator
lamp illuminates in a constant green glow,
programming is complete. The garage
door, gate or similar should now be acti-
vated when the programmed button is
depressed.
Flashes green 10 times per second:
Depress the button being programmed,
hold it depressed for 2 seconds and
then release it. Repeat the sequence of
pressing/holding/releasing a second time
and, depending on the receiver model,
even a third time. Programming should
now be complete and the garage door,
gate or similar should now be activated
when the programmed button is
depressed.
If the receiver is still not activated:
Continue with programming steps 6-8 to
complete programming.
Button designation and colour vary depending on manufacturer.
30
®
button
6. Locate programming button
receiver for the garage door or similar. It is
normally located near the antenna bracket on
the receiver.
7. Depress and release the receiver's program-
ming button. Step 8 must be completed
within 30 seconds of the button being
depressed.
8. Depress the button being programmed, hold
it depressed for 2 seconds and then
release it. Repeat the sequence of press-
ing/holding/releasing a second time and,
depending on the receiver model, even a
third time. Programming is now be com-
plete and the garage door, gate or similar
should now be activated when the pro-
grammed button is depressed.
Operation
When HomeLink
used in place of the separate original remote
controls.
Depress the programmed button. The garage
door, gate, alarm system or similar is activated
(may take a few seconds). If the button is
depressed for more than 20 seconds then the
programming is deleted. The indicator lamp illu-
minates or flashes when the button has been
30
on the
depressed. Naturally the original remote controls
can still be used in parallel with HomeLink
required.
NOTE
If the ignition is switched off, HomeLink
work for 30 minutes after the driver's door
has been opened.
In the event of programming problems, contact
HomeLink
www.youtube.com/HomeLinkGentex or call the
toll-free number 00 8000 466 354 65 (or the
toll number +49 6838 907 277).
Resetting the HomeLink
It is only possible to reset all of the HomeLink
buttons at the same time, not each button indi-
vidually. However, individual buttons can be
INSTRUMENTS AND CONTROLS
®
is fully programmed it can be
®
®
®
at www.HomeLink.com,
®
buttons
if
will
®
}}
163
Advertisement
Table of Contents
