How To Use - Electrolux EKGE20C2NMS Instruction Manual

47 electrolux how to use

How to use

Before using the range for the first
time
01. Clean the stainless steel cook top
removing all plastic tape according
to the cleaning instructions.
02. For first time use, heat the empty
oven for 45 minutes to the
maximum temperature.
03. Let the oven cool down and then
wipe with warm water.
04. All accessories including pan
grates and backing racks should
be washed before using for the
first time.
05. When using the oven for the first
time, keep it lighting for several
minutes to remove the normal
smells and gases that are
produced.
Glass lid
01. Before closing the glass lid be
sure that all burners have cool
down. Never light the burners with
the glass lid closed. The heat and
flames might break the glass.
02. When closed, the range lid
purpose is to protect the surface
against dust and, when opened, to
prevent fat spatter in the back
wall.
03. Do not use the lid as a work
surface.
04. Do not place heavy or hot objects
over the glass lid (maximum
3.0kg/6,5lb and 50ºC/125ºF).
Burner ignition
01. Choose the knob of the burner
that you want to light.
02. Electric ignition:
Press the ignition button and at
the same time turn the knob
counterclockwise until the
burners light. After ignition
occurs, the oven burner knob
should be held for 15 seconds to
allow the flame sensor to reach
the required temperature.
03. Select the temperature.
04. Turn the knob to off position to
turn of the burner.
Burner
position
Off
Temp.
Máximum
Temp.
Minimum
Electric ignition
Oven light
01. Press the button that indicates
the oven light to turn the light on.
02. To turn the light off, press the
button again.
Timer (only in some models)
To use the timer, determine the ringer
by turning the knob clockwise. The
ring in the end of the cooking does
not interrupt the operation.
Touchpad (only in some models)
Press Touchpad controls to select the
following functions:
1. Timer or clock timer
2. Oven light
Standby mode
Standby mode is the sleeping state of
the interface that only clock is
displayed and all the buttons are not
highlighted. Default mode is the
starting point to initiate a countdown
process, edit Clock/Timer and turn on
the light of the cavity.
To "wake up" the interface and go to
Default mode, press any button. This
action enables Timer/Reloj button. If
any action does not occur in 60
seconds in Default mode, the
interface automatically goes to
Standby mode.
how to use electrolux 48
Light switch
It is normal that all the burners have
continuous sparkling when pressing
the electric ignition.
beep 1 beep 1 beep 1