Waste Disposer - No Air Gap - Danby DDW1801MW Instructions Manual

Option 3 - Waste Disposer - No Air Gap:
1. Remove the disposer knockout plug. Do not cut end of drain hose.
2. Attach drain hose to disposer inlet with large spring type clamp. This
connection must be before the drain trap and at least 20" (50.8 cm)
above the fl oor where dishwasher will be installed. It is recommended
that the drain hose be looped up and securely fastened to the under-
side of the counter.
3. Insert drain hose through hole cut in cabinet to the front center of
opening where drain connection will be made.
Option 4 - No waste disposer – no air gap:
1. Cut end of drain hose if needed (do not cut
ribbed section).
2. Attach drain hose to waste tee with 1-1/2" to 2"
(3.8 to 5 cm) screw-type clamp*. This connection
must be before the drain trap and at least 20"
(50.8 cm) above the fl oor where dishwasher will
be installed. It is recommended that the drain
hose be looped up and securely fastened to the
underside of the counter.
3. Insert drain hose through hole cut in cabinet to
the front center of opening where drain connec-
tion will be made.
* Parts should be available from a local plumbing
supply store.
INSTALLATION INSTRUCTIONS
Drain Trap
Drain Hose - Cut here
if needed
Waste Tee
Drain Tap
10
Large spring-
type clamp
Drain hose
Disposer inlet
Drain Hose
Screw-type
clamp
Drain Hose
Drain Hose