How To Use This Manual; Getting Ready; Installation Requirements - Panasonic EYFR02 Operating Instructions Manual

I
. INTRODUCTION
Thank you for purchasing the Panasonic Assembly Qualifier. The AQ Wireless can monitor
battery tools. In its simplest form, the AQ Wireless is configured to monitor a tool while it's
running, determine if the fastening process was successful, report the status of the fasten-
ing, and perform counting functions.

How to Use This Manual

• Please read this manual completely before starting to use your AQ Wireless. If this unit is
mishandled a fatal accident, bodily injury, or damage to the AQ Wireless may occur.
• This manual is intended to be a general guide to the operations of the AQ Wireless. If any
additional questions or concerns arise, please contact a Panasonic Electric Works Power
Tools representative.
• Please keep this manual for future reference. It contains important safety information that
you must follow to use the AQ Wireless safety.
WARNING!
• Do not disassemble the unit for repair or modifications. There is a high electrical voltage
inside the unit that could cause electric shock.
• Do not allow any type of liquid to come into contact with any part of the unit.
• Immediately discontinue use of the unit if smoke, an abnormal odor, or an unusual
sound is detected coming from the unit.
• Insert all fittings fully into their mating receptacles. Failure to do so could result in injury.
• Do not fold, bend or apply excessive force to any cable or fitting.
CAUTION!
• This unit accepts an AC input voltage from 90VAC to 64VAC. Trying to operate this unit with a
voltage outside that range may cause damage to the unit.
• Reception reliability may vary with site conditions. Be sure to verify proper Assembly Qualifier
operation, including data reception, before starting work. Panasonic is not responsible for any
damage sustained as a result of reception problems.
• Avoid placing or storing this unit in a location where it may become wet or dust covered.
• Do not place or mount this unit in an unstable area.
Dropping this unit may result in personal injury or damage to the unit.
• Before performing any maintenance on the unit, make sure to turn it off and remove the power plugs.
• There are no user serviceable parts inside the main enclosure of the unit.
• Proper operation is not guaranteed in the event that the Assembly Qualifier has been modified in any way.
• Always use this Assembly Qualifier with a Panasonic tool. Proper operation is not guaranteed
when used with non-Panasonic tools.
Always turn the Assembly Qualifier's power off when not in use.

Getting Ready

Installation requirements

Select SIGNAL STRENGTH on the third menu screen and verify the wireless signal strength.
Install the unit in a location where the signal strength is at least -100 dBm. If you are unable
to get a reading of at least -100 dBm, check for obstructions between the Assembly Qualifier
and the tool. However, temporary interference or other issues may interrupt communications.
Be sure to test the Assembly Qualifier adequately at the site where it is to be used. Using the
4 screw holes, mount the Assembly Qualifier securely so that it will not fall off the wall. The
Assembly Qualifier may cause injury if it falls from the installation location.
- 3 -