3. FAN SHROUD GRILLE
1) Loosen two screws after disconnecting a cap screw of a
grille fan (U) with a screwdriver balde.
2) Disassembly of a grille fan (U) : Pull forward after
opening hook at ➝ part with a screwdriver blade.
3) Disconnect housing A of a grille fan (L) from the main
body.
4) Disassembly of a grille fan (L) : Hold upper part of a
grille fan (L) and pull forward carefully.
5) Loosen two screws.
6) Disassembly of shroud. F (U) : Disconnect housing of B
after removing two rail guides with a screwdriver blade.
7) Disassembly of shroud. F (U) : Hold upper part and pull
forward.
8) Check foam sticking conditions around a shroud, F (U)
and F (L) during assembling. If damaged, torn, or badly
stuck, assemble with a new one after sealing well.
4. ICEMAKER ASSEMBLY
1. Dispenser Model
1) How to disassemble:
(1) Remove ice bank from the freezer compartment.
(2) Loosen two screws on the upper part of icemaker
bracket.
(3) Disconnect icemaker bracket so that it can slide
forward.
(4) Disconnect icemaker housing and sensor housing.
(5) Disconnect icemaker horizontally by pressing bracket
hook part. ( Don't disassemble further. The set value
may be changed.)
2) How to assemble : The assembly is the reverse order of
the above disassembly.
Bracket, Ice Maker
Ice Maker Unit
Tray, Ice
Insulation
Sensor
Cover, Sensor
Note : When the ice tray is not horizontal after assembly,
assembly must be wrong. Check and assemble
again.
- 97 -
Hook
Lever