Prestige Platinum+ APS 786 Installation Instructions Manual page 6

WIRING CONNECTIONS: Multi Pin Accessory Input/Output Harness
White w/ Red Trace Wire: Parking Light Flasher Feed
This wire is the common contact of the on board parking light flasher relay. If the vehicle you are
working on has +12 volt switched parking lights, connect this wire to a fused + 12 volt source. (Max. 15
Amps)
NOTE: If the vehicle's parking lights are ground switched, connect this wire to chassis ground.
White Wire: Parking Light Flasher Output
This wire is the normally open contact of the on board parking light flasher relay. Connect this wire to the
vehicle parking light feed wire. See diagram below for details on wiring positive switched parking light
circuits.
White w/ Black Trace Wire: (+) Siren Output
This is the positive siren feed wire. Route this wire through a grommet in the firewall to the siren
location. Connect the White w/ Black Trace wire to the Red wire of the Siren. Secure the Black wire
of the Siren to a known chassis ground or solid clean metal surface.
SIREN
Parking Light Wiring Detail
Siren Wiring Detail
TO WHITE w/BLACK WIRE OF MODULE
(-) TO VEHICLE'S CHASSIS GROUND
6
128-6531
6 of 24