Philips MCD755 User Manual page 38

Troubleshooting
Considerable noise in radio broadcasts.
The remote control does not function.
The display is dark.
Low hum or buzz sound.
Low bass response.
Unable to select Progressive Scan.
No sound is output from the HDMI jack.
38
✔
Tune in to the correct frequency.
✔
Connect the antennas.
✔
Fully extend the FM wire antenna. Position for
best reception and secure to a wall.
✔
Connect an outdoor FM antenna.
✔
Adjust the direction and position for best
reception.
✔
Place the antenna farther away from any
equipment that may be causing the noise.
✔
Increase the distance between the system and
your TV or other equipment.
✔
Select the correct source (DISC or TUNER, for
example) before pressing the function button.
✔
Point the remote control at the remote sensor
of the unit.
✔
Reduce the distance to the player.
✔
Remove any possible obstacles.
✔
Replace the batteries with new ones.
✔
Check that the batteries are loaded correctly.
✔
Press DIM again.
✔
Place the DVD micro system as far away as
possible from electrical devices that may be
causing interference.
✔
Check all speakers for correct polarity.
✔
Check that the output of the video signal is
switched to 'Pr/Cr Pb/Cb Y'.
✔
Check the connection between the TV and the
HDMI jack of the DVD player.
✔
See if the TV supports this 480p/576p/720p/
1080i DVD player.
✔
Check your TV system setup correctly.