Table of Contents
Advertisement
Indoor unit installation
When deciding on the location of the air conditioner with the owner, the following restrictions must be taken into account.
1
Place the pattern sheet on the ceiling at the spot where you want
to install the indoor unit.
Since the diagram is made of paper, it may shrink or
stretch slightly due to temperature or humidity. For this
reason, before drilling the holes maintain the correct
dimensions between the markings.
2
Insert bolt anchors. Use existing ceiling supports or construct a suit-
able support as shown in figure.
3
Install the suspension bolts depending on the ceiling type.
of the indoor unit. Before hanging the unit, test the strength of
each attached suspension bolt.
it is required to prevent vibration.
order to be able to use it to perform the required operations on
the indoor unit.
4
Screw eight nuts to the suspension bolts making space for hanging
the indoor unit.
You must install all the suspension rods.
5
Hang the indoor unit to the suspension bolts between two nuts.
suspending the unit. If the ceiling is already constructed, lay the
piping into position for connection to the unit before
placing the unit inside the ceiling.
6
Screw the nuts to suspend the unit.
7
Adjust level of the unit by using measurement plate for all 4 sides.
For proper drainage of condensate, give a 0.118inch(3mm)
slant to the left or right side of the unit which will be connected
with the drain hose, as shown in the figure. Make a tilt when
you wish to install the drain pump, too.
28
Concrete
Hole in anchor
hole in plug
Suspension bolt(M8)-field supply
Ceiling support
When the drain hose is installed to the right.
Drain hose port
Insert
Hide quick links:
Advertisement
Table of Contents
