End Door Removal / Installation (Bhd4P Only); Control Panel Removal - Napoleon BHD4P Installation And Operating Instructions Manual

6.4

END DOOR REMOVAL / INSTALLATION (BHD4P ONLY)

NOTE: One of the main safety screens and doors must be removed prior to end door removal, see
"MAIN SAFETY SCREEN REMOVAL/INSTALLATION" and "MAIN DOOR REMOVAL / INSTALLATION"
sections for detailed removal instructions.
Remove the 6 screws securing the end door in place, as shown below. Ensure to keep one hand on
A.
the door, from the inside of the appliance, at all times to prevent it from falling.
Tilt the door from the top downwards and carefully remove it from the appliance.
B.
To install the end door, reverse these steps.
C.
6.5

CONTROL PANEL REMOVAL

Remove the main safety screen, see "MAIN SAFETY SCREEN REMOVAL / INSTALLATION" section.
A.
Remove the panel cover using the two finer holes, lift it up and away from the appliance, as shown
B.
below.
Remove the control panel cover by lifting it up and off of the four shoulder screws, as shown below.
C.
6 screws
PANEL COVER
CONTROL
PANEL COVER
37
EN
W415-1285 / F / 12.21.16