Superior VRE4536WS Installation And Operation Instructions Manual page 12

REFRACTORY PANEL INSTALLATION
IMPORTANT: Installation of brick should be done after
the fi replace is placed in a permanent location.
1. Remove screen assemblies and all hardware components out of
the fi rebox. The bottom panel is preinstalled in the fi rebox. Make
sure the bottom refractory panels is centered in the fi rebox and
fl ush with the front of the fi replace.
2. Place cardboard on top of bottom refractory panel as a protection
to prevent shipping and scratching during installation of the other
panels.
3. Install rear refractory panel. This panel has a top and bottom. To
determine which is which, match up the pattern on the rear panel
with the left and right sides before installing the rear panel. Make
sure panel is center before continuing.
4. Install the right and left refractory panels with the gas line knock-
outs orientated down toward the bottom refractory. Align the left
and right panels with the rear panel so the grout lines line up.
5. Install the upper corner brackets and tighten set screws (Figure
13).
LEFT BRICK
PANEL
ASH PANEL
Figure 13 - Installing Refractory Panels
12
INSTALLATION Continued
UPPER CORNER
BRACKET (2x)
REAR BRICK
PANEL
RIGHT BRICK
PANEL
BOTTOM
BRICK PANEL
SuperiorFireplaces.US.com
INSTALLING FIREPLACE HOOD AND SCREENS
1. Attach hood to fi rebox using screws provided (see Figure 14).
1. Slide round end of screen rod into rings at top of screen. Attach one
push-on nut to end of rod before attaching last ring of screen.
2. Insert the round end screen rod into hole on the left and right side
of smoke shelf (Figure 15).
3. Mount fl at end of screen rod with #10 x 5/8" to center of smoke
shelf.
4. Install other screen rod in same manner.
Screws
Figure 14 - Screw and Hood Placement
Rating
Plate
Figure 15 - Installing Fireplace Screen
Hole for Screen
Rod
Leading
Bricks
127029-01D