Access The System Remotely - Dell Z9000 Quick Start Manual

Access the System Remotely

You can configure the system to be accessed remotely by Telnet. The Z9000
system has a dedicated management port and a management routing table that is
separate from the IP routing table.
To access the system remotely, follow these steps:
Step Task
Configure an IP address for the management port
1
Port IP Address).
Configure a management route with a default gateway
2
Management
Configure a username and password
3
Configure the Management Port IP Address
In order to access the system remotely, assign IP addresses to the management
ports.
To configure the management port IP address, follow these steps:
Step Task
Enter INTERFACE
1
mode for the
Management port.
Assign an IP address
2
to the interface.
Enable the interface.
3
18
Installing the Software
Route).
Command Syntax
interface ManagementEthernet
slot/port
ip address ip-address/mask
no shutdown
(Configure the Management
(Configure the
(Configure the Username and Password).
Command Mode
CONFIGURATION
INTERFACE
INTERFACE