Basic Span-Se Set-Up - Novatel SPAN-SE User Manual

SPAN-SE Installation
5
4
12V
Reference
1
2
3
4
5
6
7
8
9
The sections that follow outline how to set up the system's parts and cables. See the specifications
starting on Page 85 for the NovAtel part numbers of SPAN-SE cables and their pinouts.
SPAN-SE User Manual Rev 1
1
4
12V
Description
SPAN-SE receiver with an on-board SD Card for data storage
User-supplied NovAtel GNSS antenna
LN-200, HG-1700 or iIMU FSAS IMU and IMU interface cable to the
connector labelled IMU on the SPAN-SE I/O 2 yellow cable. For
the other connections, that only apply to the iIMU-FSAS, see
Section A.2.2.1, iIMU-FSAS Interface Cable starting on Page 77.
User-supplied power supply:
SPAN-SE rover (1):
ProPak-V3 base (6):
Separate supply for IMU (3):
User-supplied radio device to the connector labelled OEMV3 on the
SPAN-SE I/O green cable.
User-supplied base station (ProPak-V3) receiver
User-supplied PC/laptop, for setting up and monitoring, to COM1 on
the ProPak-V3, or in the case of the SPAN-SE to one of the four
available COM ports, the USB host port or the Ethernet port
SPAN-SE I/O 1 green cable see Section A.1.1.2, I/O 1 Green Cable
(NovAtel part number 01018134) on Page 65
SPAN-SE I/O 2 yellow cable see Section A.1.1.3, I/O 2 Yellow
Cable (NovAtel part number 01018133) on Page 67
Figure 3: Basic SPAN-SE Set-Up
Rover
Base
4
+9 to +28 V DC
+9 to +18 V DC
see Table 3 on Page 32
Chapter 2
27