Table of Contents
Advertisement
This Product is a zoom lens designed for 35 mm PL mount cameras.
(1) INSTALLATION ONTO CAMERA
Note. Prior to installation of the lens, turn off the power of the camera and, if used, the external power source.
WARNING Be sure to attach all the parts securely.
Dropping any parts from a height may cause severe accidents.
SLIT (4 PLACES)
a. Take the rear lens cap off.
b. Rotate the mount clamp ring on the camera fully counterclockwise.
c. Fit the mounting surface of the lens to that of the camera, aligning the pin on the camera with a slot in the
lens.(The position of the pin depends on the model of the camera.)
d. Rotate the mount clamp ring fully clockwise.
Note.
Make sure to adjust the flange focal length when installing the lens on a camera for the first time or
installing it on another camera (refer to page 5).
BRACKET
LENS SUPPORTER
GENERAL DESCRIPTION
INSTALLATION
MOUNT FACE OF LENS
BRACKET
THREADED HOLE FOR LENS SUPPORTER (3/8-16UNC)
BRACKET INSTALLED
MOUNT FACE OF CAMERA
PIN (POSITION DEPENDS ON CAMERA)
CAMERA
MOUNT CLAMP RING
LENS
- 3 -
CAMERA
Advertisement
Table of Contents
