Prestige APS 685 Installation Instructions Manual page 13

4 channel remote start / keyless entry system
Table of Contents

Advertisement

Dark Blue/Black and Green/White - 2 Pin Input/Output Harness:
Dark Blue/Black Trace Wire: External Trigger Input
The Dark Blue/Black trace wire allows the remote start unit to be activated from an external source. The
intent of this wire is to allow the unit to be controlled from a "POSSE/CAR-LINK" paging system or similar
device. When this wire receives a ground pulse, the unit will start the vehicle. Connect this wire to a
ground pulsed output from the controlling circuit.
Green w/ White trace Wire: Entry Illumination Ground Output
This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to unlock the
doors . This wire should be connected to an external relay, and wired to the vehicles interior entry lighting
whenever the optional Interior Illumination circuit is desired. See below for relay wiring details.
1. RF Programmable Features:
Feature
1 Flash
1st
Door Lock O/P
1S/1S
2nd Auto Locks
On
3rd
Auto Unlock
Dr. Door
4th
Run Time
5 Min
5th
Lights
On Steady
6th
Input Check
NA
7th
NA
NA
8th
Ign 2 Crank
Off
9th
Diagnostics
Off
10th NA
NA
11th Gas/Diesel
Gas
12th 2nd Step Unlock
On
NOTE: When selecting Diesel operation, (Feature #11), over gasoline, the only change is to the ignition
circuits. When Diesel is selected, the ignition circuits will power up for X seconds, as dictated by
the feature selection, before the start circuit. The intent of this feature is to allow the glow plug
warming required by some diesel engines. If your vehicle is a instant start diesel, it is not necessary
to activate this feature.
NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be
certain to connect the tach input wire.
To program these selectable features:
1. Turn the ignition key to the ON position.
2. Press and release the pushbutton switch 3 times
3. Immediately turn the ignition key OFF, then back to ON.
4. Press and release the pushbutton switch 2 times.
Entry Illumination Detail
2
2 Flash
3.5S/3.5S
Off
All Doors
10 Min
Flash
Tach
NA
On
On
NA
Diesel 10
Off
3 Flash
1S/Dbl1S
Off
15 Min
NA
Diesel 15
13
4 Flash
Default
1S/1S
Off
Off
20 Min
10 Min.
Steady
Tach
NA
On
Off
NA
NA
Diesel 20
Gas
Off

Advertisement

Table of Contents
loading

This manual is also suitable for:

Platinum+ aps 685

Table of Contents