Warning; Assembly - Baby Trend HC34A Instruction Manuals

WARNING

WARNING:
Failure to follow these warnings and the
instructions could result in serious injury or death.
WARNING:
Prevent serious injury or death from falls
or sliding out. Always use the restraint system.
• NEVER leave child unattended.
WARNING:
The child should be secured in the
high chair at all times by the 5-point restraining system,
either in the reclining, semi-reclining or upright position.
The tray is not designed to hold the child in the chair.
It is recommended that the high chair be used in the
upright position only by children capable of sitting upright
unassisted. See page 8 for instructions on proper use of
restraint system.
• Other accessory items may change the balance of the high chair and cause
hazardous unstable conditions, use approved Baby Trend toys.
• Be certain the high chair is fully erect and latched in the open position before
allowing the child near the high chair.
• Use of the high chair with a child weighing more than 40 pounds will cause
excessive wear and stress on high chair.
• The maximum weight that can be carried in the basket is 5 lb. Excessive weight
may cause a hazardous unstable condition to exist.
• NEVER allow your high chair to be used as a toy.
• NEVER use this product if there are any loose or missing fasteners, loose joints,
broken parts, or torn mesh/fabric. Check before assembly and periodically during
use. Contact Baby Trend Customer Service at 1-800-328-7363 for replacement
parts, repair or instructions. NEVER
3
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
substitute parts.
IMPORTANT!
To ensure safe operation of your product, please
follow these instructions carefully. Please keep these instructions for
future reference.
IMPORTANT!
Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges. NEVER
use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
IMPORTANT!
Always check that the high chair is locked in the
open position before using.
ATTENTION:
Carefully remove parts from box. Check that
you have all the parts for this model before
NOTE:
assembling the high chair. Certain
High Chair models are packaged with the
High Chair Seat Fabric and Seat Insert
already attached to the Seat Back.
TO ASSEMBLE SEAT
1) • Place the Seat Base on a flat surface.
2) • Join the Seat Back to the Seat Base
using the Seat Back Hinge Rod (Fig. 2a).
To install the hinge rod, press down on
the hinge rod retainer and insert the rod
into the hinge from right to left (Fig. 2b).
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

ASSEMBLY

Seat Back
Seat Base
Fig. 2a
Seat Back Hinge Rod
Hinge rod retainer
Fig. 2b
4