Installing The Pneumatic Unit - Brother BAS-326H-484 Instruction Manual

3. INSTALLATION

3-11. Installing the pneumatic unit

Valve nos.
2. Connect each of the air tubes (5) to the valves so that all of the numbers match respectively.
The air tubes (5) marked with an A connect to the front valve connections (A), and those marked with B connect to the rear
connections (B).
3. Open the air cock (6).
18 BAS-326H-484, BAS-326H-484 SF
1. Install the pneumatic unit underneath
the work table.
(1) Solenoid valve assembly
(2) Washers [2 pcs.]
(3) Wood screws [2 pcs.]
(4) Rubber hose
NOTE:
Make sure that the pneumatic unit
does not touch the control box or the
work table leg.
3732B
After installing the pneumatic unit,
adjust the air presser.
(Refer to "7-17. Adjusting the air pressure".)
3733B