One-Touch Timer Recording - Philips DVDR3435V/37 User Manual

32

One-touch Timer Recording

DVD+ DVD+RW DVD+RW DVD+R DVD+R DVD+R
This is a simple way to set the recording time in blocks of 30 minutes.
Check that the disc you are recording onto has enough space for the time
you set.
When the recording finishes the recorder automatically goes into standby
mode.
Press [DVD] first.
1
Turn on the unit and load a recordable disc.
Make sure that the TV input is set on the unit.
This operation may take a while to be recognized.
2
Using [REC MODE], select a recording mode.
Refer to "Recording mode" on page 28.
3
+
Using [CH /
channel to record.
4
Press [DVD REC I] repeatedly to select desired recording
time.
Recording times appear on the TV screen (30 minutes to 6 hours).
Recording will start.
I
0:30
0:30
(Normal Recording)
6:00
When the unit reaches the specified time, it will be turned off
automatically.
To change the recording length during the One-touch Timer
Recording, press [DVD REC I] repeatedly until the desired length
appear.
To cancel the One-touch Timer Recording within the specified time,
press [STOP C].
This operation may take a while to be recognized.
E9A90UD_EN.indb 32 E9A90UD_EN.indb 32
+VR
+VR
DVD-RW DVD-RW DVD- DVD-R DVD-R DVD-R
-
] or the Number buttons, select a desired
1:00
5:30
DISC MENU SETUP
OK
BACK
DISPLAY
PLAY
REW FFW
PREV PAUSE NEXT
4
COMMERCIAL STOP
SKIP
DIRECT
TV DUBBING
CH
VOL
.@/: ABC DEF
GHI JKL MNO
PQRS TUV WXYZ
CLEAR REC MODE
VCR REC VCR Plus+ TIMER DVD REC
TIMER SET
Helpful Hints
• The remaining recording
time will appear on the
display panel during a One-
touch Timer Recording,
press [DISPLAY] to see the
remaining recording time
on the TV screen.
• You cannot pause a One-touch
Timer Recording.
• Unlike a Timer Recording,
you can perform the following
operations during a One-touch
Timer Recording.
- Turning the power off.
- Using [DVD REC I] and
[STOP C].
• The unit will be turned off
automatically under the
following conditions.
1) No space remained on the disc.
2) When a power failure occurs.
• If OTR is finished in DVD during
playback or REC mode in VCR,
the DVD will be in STOP mode
and the VCR keeps the current
mode.
• When OTR is finished and
the power is turned off,
the unit will switch to the
standby mode automatically if
a Timer Recording has been
programmed. Press
[TIMER SET] to cancel the
standby mode for using the unit
continuously.
3
2
6/12/2006 4:21:28 PM 6/12/2006 4:21:28 PM