General Information - Philips DVD712 Owner's Manual

Digital video disc player
Hide thumbs Also See for DVD712:
Table of Contents

Advertisement

8 General Information

Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the back of the
remote control by pressing in the tab, then lifting off the lid .
2
Place two AA batteries inside the battery compartment with
their + and – ends aligned as indicated. Do not mix old and new
batteries or differ ent types of batteries (standard, alkaline, etc.).
3
Replace the battery compartment lid.
Using the Remote Control
Unless stated otherwise, the remote control can perform all
operations. Always point the remote control directly at the
remote sensor on the front of the DVD Player, not the TV.
Details are on page 20. Make sure there are no barriers
between the remote control and the DVD Player.
Environmental Information
Your system consists of materials that can be recycled and
reused if disassembled by a specialized company. Please observe
the local regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
Safety Information
Do not expose the system to excessive moisture, rain, sand,
or heat sources.
Place the DVD Player on a firm, flat surface.
Keep the DVD Player away from domestic heating equip-
ment and direct sunlight.
When placing the DVD Player in a cabinet, allow about one
inch of space all around the DVD Player for ventilation.
Cleaning Discs
When a Disc becomes dirty, clean it with a cleaning cloth.
Wipe the Disc from the center out, in a straight line.
Do not use solvents such as benzine, thinner, commercially
available cleaners, or anti-static spray intended for analog discs.
If the DVD Player cannot read Discs correctly, use a com-
monly available cleaning CD/DVD to clean the lens. Other
cleaning methods may destroy the lens. Always keep the tray
closed to avoid dust on the lens.
The lens may cloud over if you suddenly move the DVD Player
from cold to warm surroundings. Playing a Disc is not possible
then. Leave the power on for about one hour with no Disc in
the unit until normal playback is possible.
+
-
+
-

Advertisement

Table of Contents
loading

Table of Contents