READ BEFORE INSTALLATION CONTENTS This product has been det ermined t o be in compliance wit h t he Low Volt age Direct ive ( 2006/95/EC), and t he Elect romagnet ic Compat ibilit y Direct ive ( 2004/108/EC) of t he European Union. 1.
1. PREPARING FOR INSTALLATION 1. PREPARING FOR INSTALLATION 1.1 SAFETY PRECAUTIONS WARNING n order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not nstalling, starting up, and servicing air-conditioning equipment can be hazardous due to system Pressures, be supplied through an external switching device, such as a timer, or connected to a circuit that is electrical components, and equipment location (roofs, elevated structures, etc.).
2. INDOOR UNIT INSTALLATION 1. PREPARING FOR INSTALLATION 1.3 INSTALLATION SITE CHOOSING 2.1 INDOOR UNIT MOUNTIN PLATE 2.2 INSTALLATION PROCESS The mounting plate will look like one of the following depending on the unit size. Step 1: Determine Wall Hole Position The holes for fixing anchors should be 5mm.
2. INDOOR UNIT INSTALLATION 3. OUTDOOR UNIT INSTALLATION Step 6: Prepare Drain Hose Step 7: Wrap Pipe and Cable Step 8: Hang the Indoor Unit 3.1 OUTDOOR UNIT MOUNTING DIMENSION The mounting dimensions vary among different outdoor units. STEP The fixing bolt head diameter should be more than 12mm. Indoor Wire Connection 1.
3. OUTDOOR UNIT INSTALLATION 4. REFRIGERANT PIPING WORK 3.3 OUTDOOR WIRE CONNECTION CAUTION Remove the electrical cover and cable clamp by loosening the screws. heck if the height difference between indoor unit & outdoor unit and the total length of refrigerant pipe meet Connect wires to the outdoor terminal block by same sequence to indoor unit.
Rated Current(A) Fuse Rating(A) (with Min. Crosse section) (with Min. Crosse section) Fully open the valve stem of the packed valves. Remove the charging hose form the service port. 38QHM009/38QHM012 11.0 3*1.5mm 5*1.5mm Securely tighten caps of packed valve. 5*1.5mm...
6. FINAL CHECK AND TRAIL OPERATION 6.1 FINAL CHECK LIST To complete the installation, perform the following checks before the trial operation. Strength of the installation site for both indoor and outdoor sides, confirm no obstruction of the unit air outlet or return. Tightness of Refrigerant piping connection and confirm no leakage Electric wiring connections are correctly completed and unit has been grounding connected Check the total length of the piping and record the volume of the additional charged refrigerant...
This manual is also suitable for:
Qhm00938qhm012Qhm024Qhm012Qhm01842qhm009es series...
Show all
42qhm012es series38qhm012es series38qhm009es series42qhm018es series42qhm024es series38qhm018es series38qhm024es series