Turn On; Store Radio Stations Automatically; Set Clock; Adjust Brightness Of Display Panel - Philips DCD322 User Manual

2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before you press any function button on the
remote control, À rst select the correct source
with the remote control instead of the main
unit.
•
If you are not going to use the remote control
for a long time, remove the battery.

Turn on

1
Press .
»
The unit switches to the last selected
source.
Switch to standby mode
1
Press and hold for over 3 seconds to
switch the unit to Eco Power Standby
mode.
»
The backlight on the display panel
turns off.
»
The blue Eco Power indicator turns on.
To switch the unit to standby mode:
1
In Eco Power Standby mode, press and
hold for over 3 seconds.
»
The clock (if set) appears on the
display panel.
»
The blue Eco Power indicator turns off.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1
Turn on the unit.
2
Press SOURCE repeatedly until
[TUNER] is displayed.
» [AUTO INSTALL PRESS----PLAY
KEY] (press
installation) is displayed.
to start the automatic
3
Press .
»
The unit automatically stores radio
stations with sufÀ cient signal strength.
»
After all available radio stations are
stored, the À rst stored radio station is
broadcast automatically.

Set clock

1
In standby mode, press and hold CLOCK
for over 2 seconds to activate the clock
setting mode.
» [SET CLOCK] scrolls on the display,
and then [24H MODE] (24-hour time
format) appears.
2
Press VOL +/- to select [24H MODE] or
[12H MODE] (12-hour time format), and
then press CLOCK to conÀ rm.
»
The hour digits begin to blink.
3
Press VOL +/- to set the hour.
4
Press CLOCK to conÀ rm.
»
The minute digits begin to blink.
5
Press VOL +/- to set the minute.
6
Press CLOCK to conÀ rm.
Adjust brightness of display
panel
1
In standby mode, press MODE/DIM
repeatedly to select different brightness
levels.
Find the correct viewing
channel
1
Press to turn on the unit.
2
Press DISC to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
EN 13