Connect Power; Ground Information - Uniden CMX760 Owner's Manual

CONNECT POWER

Uniden recommends connecting the power lead
to the Ignition Switch Accessory Terminal. This
way, the radio is automatically turned off when the
ignition switch is turned off.
As an alternative, the power cord may be
connected to an available terminal on the fuse
block or to a point in the wiring harness. However,
caution must be taken to prevent a short circuit.
If in doubt, contact your vehicle dealer for
information.
The CMX760 can operate on 12VDC power supply.

Ground Information

This radio may be installed and used in any 12-
volt DC negative ground system vehicle.
With a negative ground system, the negative (-)
battery terminal is usually connected to the vehicle
motor block.
Connect the red DC power cord from the radio to
the positive (+) battery terminal or other convenient
point. Then connect the black power cord to the
vehicle chassis or negative (-) battery terminal.
11