Page 15
1800 W 220-240 V 50 Hz Dear Customer Thank you for choosing a NESCO appliance. The experience, design, feature and technology of this appliance, as well as the strict quality controls used during manufacture, will provide full satisfaction for many years.
Introduction Carefully read and understand this annual and any label attached to the tool before use. Keep these instructions with the product for future reference. Ensure all persons who use and service this product are acquainted with this manual. Many usages as below To wash up cars, motorcycles, electric motor cars and other motor vehicles.
Page 17
Children & pets -should always be kept at a safe distance from your work. Make your workshop child-proof. Lock tool away where children can’t get access to them. Remove batteries from cordless tools. Use the correct power tool -Don’t force, or attempt to use a power tool for apurpose it was not designed for.
Page 18
Do not abuse the power cord -Be sure your cable/extension cable is properly wired and in good condition. Always replace a damaged cable/ extension cable or have it repaired by aqualified person before using it. Never yank or pull the cable to disconnect it from the power socket.
Page 19
When using an extension lead, make sure it is 13 amps fused, and no longer than 25 metres. If using acable reel, ALWAYS fully unwind the cable before using (if left wound, it can generate heat and be a potential fire hazard). Only use a cable that is recommended for outdoor use.
Page 20
Fix unit body and detergent tank by screws. (see fig.3) Fix storage brackets to unit body by screws.(see fig.4) fig.3 fig.4 Connect the nozzle onto the spray lance and the lance onto the gun handle. (see fig. 5,6,7) fig.5 fig.6 fig.7 Loosen the high pressure hose to avoid twist.
Page 21
Connect the water supply hose to the water entry of the machine. (see fig.10) Connect another end of the supply hose to water source. fig.10 Press the gun trigger and turn on the water tap to expel the air inside the machine. Plug in and turn on the machine.
Page 22
OPERATING INSTRUCTIONS Silverline Pressure Washers are fitted with an ‘Autostop’ feature which means that the machine is only activated when the lance trigger is depressed, and automatically deactivates the water flow when the trigger is released. This saves water and power, and gives the user greater control of the product. In ‘Autostop’...
Trouble Shooting Guide Problem Problem Cause Remedy Plug is not well connected or Check plug, socket and fuses. electric socket is faulty. When switched On The main voltage is insufficient, Check the main voltage is the machine will not lower than minimum adequate.
MAINTENANCE & CLEANING When It is highly recommended that you clean the nozzle with the cleaning pin (see fig.13) after each use. fig.13 To avoid blockages and potential resitriction of water supply the water intake filter should be visually checked and cleaned. Please note: This machine has a closed lubrication system, and no additional oil or lubricant is required.