Dell D90D7 Installation Manual page 21

Installing Firmware
Figure 17 Browse to select commandsXml.xml example
9. Navigate to the image folder (on your hard drive) that contains the firmware image
you extracted (this is the location you selected in "Step 1: Download and Ready the
Firmware You Require"), click on the commandsXml.xml file to select it (you may
need to select the All Files option from the Files of Type box to display the
commandsXml.xml file for selection), and then click Open.
CAUTION: Be sure to use the commandsXml.xml file you extracted in "Step 1:
Download and Ready the Firmware You Require"; DO NOT use the
commandsXml.xml file directly from an .exe or .zip download.
10.In the browse dialog box, click Next to open the Prepare the USB Drive dialog box.
Figure 18 Prepare USB Drive
11. Select the USB key onto which you want the configurations (you can use Refresh as
needed to recognize an inserted USB key), and then click Next. The progress bars
show the overall (formatting and configuration) progress and task progress.
CAUTION: DO NOT interrupt the formatting and configuration process. All process
requirements are done automatically. The progress screen may display for several
seconds or longer. You can safely ignore any error message.
12.After configuration, click Finish to close the wizard and then remove the configured
USB key for use (you will use the configured USB key on your target devices).
TIP: At this time you can also replicate/duplicate the configured USB key (containing
the firmware you want to push) for simultaneous usage on target devices (by users in
several locations at the same time). For full Wyse USB Firmware Tool details, see Users
®
Guide: Dell Wyse USB Firmware Tool 1.20.0.1.
17