Functional Description; Adjusting The Nailing Depth - Makita AN930H Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always disconnect the air hose before adjusting or
•
checking function on the tool.

Adjusting the nailing depth

CAUTION:
Always disconnect the hose before adjusting the
•
depth of nailing.
1
013449
This toll has the adjuster of the nailing depth. To
modulate the nailing depth, turn the adjuster to the
proper depth.
1 2
009180
The adjustable range is 10 mm (3/8"). (One full turn
allows 1.25 mm (1/16") adjustment.)
Hook
CAUTION:
Always disconnect the hose when hanging the tool
•
using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
013450
1. Adjuster
1. Too deep
3
2. Flush
3. Too shallow
1. Hook
1
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
Furthermore, this hook can be turned by hand to the
desired angle of the tool.
1
013451
When changing the installation position, remove the
screw with a screwdriver. Install the hook on another
side for installation and then secure it with the screw.
Use the nose adapter
CAUTION:
Always disconnect the hose before installing or
•
removing the nose adapter.
If you like to protect the surface of workpiece, attach the
nose adapter of contact element.
2
3
013453
When nailing workpieces with easily-marred surfaces,
use the nose adapter.
To detach the nose adapter from its housing base, turn
the nose adapter in the direction of the arrow.
1
013452
To attach the nose adapter to the contact element,
press it onto the contact element until the protrusion in
two places inside the nose adapter fit in two holes in the
contact element.
5
1. Screw
1. Hole
2. Protrusion
3. Nose adapter
1
1. Push
2. Nose adapter
2