GE MI-869 Instruction Manual page 171

CHAPTER 4: SETPOINTS
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
LED 5 (6-17) TRIGGER
Range: Off, Any operand from the list of FlexLogic operands
This setpoint requires the assigning of a FlexLogic operand to trigger the selected LED
upon operation.
LED 5 (6-17) TYPE
Range: Self-reset, Latched
The setpoint defines the type of LED indication as either Self-Reset (the LED resets after
the FlexLogic operand drops out), or Latched (the LED stays latched upon dropping out
of the FlexLogic operand).
Default LED setpoints for the 869 relay are as follows:
LED 1: IN-SERVICE – non-programmable. The LED is hardcoded to show a green light
when the relay is fully functional, and a red light when the relay is not programmed, or
experiences a self-test error.
LED 2: TRIP - see the default setpoint above and the description
LED 3: ALARM - see the default setpoint above and the description
LED 4: PICKUP – non-programmable. The LED is hardcoded to show a green light
when at least one element has picked up.
LED 5 - Programmable
Name: TEST MODE* - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Testing On
Type: Self-reset
* Reserved for future release
LED 6 - Programmable
Name: MESSAGE - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Active Target
Type: Self-reset
LED 7 - Programmable
Name: LOCAL MODE - Range: Up to 13 alphanumeric characters
Color: Orange
Trigger: Local Mode ON
Type: Self-reset
LED 8 - Programmable
Name: STOPPED - Range: Up to 13 alphanumeric characters
Color: Green
Trigger: Motor Stopped
Type: Self-reset
LED 9 - Programmable
Name: STARTING - Range: Up to 13 alphanumeric characters
Color: Green
Trigger: Motor Starting
Type: Self-reset
LED 10 - Programmable
Name: RUNNING - Range: Up to 13 alphanumeric characters
Color: Green
Trigger: Motor Running
Type: Self-reset
DEVICE
4–53