Philips 29PT9221/93 Manual page 17

Satellite Receiver with a recorder
Monitor
out
VIDEO
L /Mono
AUDIO
5
R
75
OUT
IN
OUT
IN
REC
DVD player or other accessory digital source equipment
Monitor AV 1 AV 2
out in
VIDEO
Y
L
Pb
AUDIO
R
Pr
Equipment with AV connectors only
& Connect the video cables to the equipment's
jacks and to the TV's
AV OUT
jacks.
é Connect the audio cables to the equipment's
and jacks and to the
AUDIO L R
or
R AUDIO AV1
(According to where you connected the video
cables, to or
AV1
Equipment with an
&
Connect an S-video cable the
input.
S-VIDEO
Note: When using the s-video connector do not
connect any device to the video input.
é
Connect the audio cables to the equipment's
and jacks and to the
AUDIO L R
jacks on the TV.
R AUDIO AV2
AV 2
AV 1
in
in
Y
S-VIDEO
Pb
3
Pr
SAT
IN
OUT
4
≈
SAT
in
S-VIDEO
or
AV1 AV2 IN
L AUDIO
jacks on the TV.
AV2
.)
AV2
connector
S-VIDEO
AV2
L AUDIO
Connect the RF Antenna or Cable TV cable 1 to
&
the socket of your recorder.
RF IN
Connect another RF cable 2 from the output of
é
your recorder to the TV's 75 ø x jack.
CABLE
Connect the satellite antenna cable 3 to the
"
satellite receiver's
Connect the AV cables 4 to the satellite receiver's
'
jacks and to the VCR's
AV OUT
(
Connect the recorder's
jacks.
AV2 IN
With Component Video Output Connectors
&
Connect the cables of your
1 to the
TV.
Note: The YPbPr sockets on the TV are compatible
with 480i (interlaced, 1 Fh) output signals only, not
480p (progressive scan, 2 Fh).
é For reproduction of CVI (Component Video
Input) and in order to have correct picture
reproduction, also connect a video cable to
video of
Note: This connection is used for
"
Connect the Audio left and right (only for
and stereo devices) cables 2 to the
input of
R
Remark: Equipment may also be connected to the
jacks (
AV IN
Warning: Never connect a signal to the Y-input
and video-input at the same time.This may
cause picture distortion !
Equipment with Progressive scan output
(480p or 1080i 2 Fh)
Connect the equipment to the
the TV.
and
See
AV3
Note: The labels for the component video sockets
may differ depending on the DVD player. Although
the abbreviations may vary, the letters B and R
stand for the blue and red component signals,
respectively, and Y indicates the luminance signal.
Refer to the DVD player's instructions for use for
definitions and connection details.
SATELLITE IN
AV IN
AV OUT
YPbPr
input
YPbPr AV1 IN
2.
AV1
.
AV1
) at the right side of the TV.
SIDE
or Digital HD input, next page.
AV4
jack.
jacks.
jacks 5 to the TV's
equipment
sockets on the
(CVBS).
AV1
and
AUDIO L
jacks on
AV4 IN
15