Yamaha MOXF6 Owner's Manual page 42

Example of VSTi Setup for USB Connection
This section describes a setup example in which the audio signal is transmitted via USB between the MOXF6/
MOXF8 and the computer.
In the following example, two audio channels are reserved for the stereo part (indicated by PART) of the
MOXF6/MOXF8, the other two channels are for the stereo A/D input part, and all four of those channels are
input to Cubase.
1.
On the MOXF6/MOXF8, set the Mode parameter to "VST" on the [UTILITY]  [F5] USB I/
O display.
To confirm the audio signal configuration created via this operation, press the [SF6] to call up the
INFORMATION window. You can see there that USB audio channels 1 and 2 are used for the A/D IN
while USB audio channels 3 and 4 are used for the stereo part of the MOXF6/MOXF8.
2.
On the VSTi Setup display of the Editor VST, set how the audio signal is input from the
MOXF6/MOXF8 to the Cubase Mixer.
Yamaha MOXF6/MOXF8-1 to 4 in the VSTi Setup display corresponds to USB 1 to 4 on the
INFORMATION window of the MOXF6/MOXF8.
In the following example, only the PART audio (USB 3 and 4) are input to the Cubase mixer and A/D
IN (USB 1 and 2) are not input.
UTILITY USB I/O INFORMATION window of MOXF6/MOXF8
VSTi Setup window of the Editor VST
You can enable the instrument channels on the VST instrument rack.
When you start the Editor VST from an instrument track, only MOXF6/MOXF8 1 becomes available.
MOXF6/MOXF8 Editor Owner's Manual
Cubase mixer instrument channels
Menu: [File] menu
42