Adjusting The Y-Sensor - Singer S-10 Service Manual

Setscrew
Y-shield plate
Y-sensor
Hop setting plate
2.5-3.5 mm
Stopper
Home position key

Adjusting the Y-sensor

1. Remove the face cover, bed cover and front
cover (do not disconnect the connectors).
B
2. Remove the carriage cover (refer to the previous
page).
A
3. Turn the power switch on to move the carriage to
the home position.
4. The gap between the stopper and hoop setting
plate should be 3 mm.
Loosen the setscrew and adjust the position of
the Y-shield plate.
5. Turn the power switch off and turn it on again to
check if the gap is 3 mm.
6. Tighten the setscrew and turn the power switch
off. Attach the carriage cover, front cover, bed
cover and face cover.
22