Table of Contents
Advertisement
Figure 5 Install/remove a PSR650-A power supply
Installing a power supply
1.
Wear an ESD-preventive wrist strap and take a new power
supply out of its package. Check that the input mode of the
power supply is correct.
2.
Grasp the handle of the module with one hand and hold the
module bottom with the other. Slide the module slowly along the
guide rails into the chassis until it snaps into the chassis
backplane.
NOTE:
To prevent damage to the power supply and the connection
terminals on the backplane, make sure to pull the module out
first in case of any misalignment, and then push it in again.
3.
Tighten the captive screws with a number No. 2 Philips
screwdriver.
6
Advertisement
Table of Contents
