Ricoh A230 Service Manual page 978

COPIER INSTALLATION
⇒
- Steps 19 to 21 are for only Europe versions when the required language is
other than English, French, and German -
19. Remove the IC card cover [A] and plug the IC card [B] which includes the
appropriate language into the IC socket.
NOTE: When setting the IC card, the surface of the card which has "B" printed
on it should be facing the front of the machine.
20. Plug in the machine and turn on the main power switch, then press the "Yes"
key. The machine automatically downloads the software.
21. After the software has been downloaded, turn off the main power switch and
remove the IC card.
22. Turn on the main power switch.
23. After the fusing warm-up period, enter the SP mode.
1) Press the "Clear Mode" key.
2) Enter "107" using the numeric keys.
3) Hold down the "Clear/Stop" key for more than 3 seconds.
4) Select "1" (copier).
NOTE: Do not enter SP mode during the fusing warm-up period (the LED of
the start key is red during this period)
24. Perform the TD sensor initial setting as follows:
1) Enter "2-801" and press the "Enter" key.
2) Press "1" to start the TD sensor initial setting.
NOTE: The machine will automatically stop when TD sensor initial setting is
completed, and the TD sensor output voltage will appear on the LCD.
25. Perform the Developer Initialization setting using SP2-805.
26. Europe: Select the correct language using SP 5-009.
A230/A231/A232
[B]
3-10
[A]
A231I537.WMF
Rev. 01/99
SM