T
he first time you turn on the new TV set, you will see a screen that helps you to auto install the programs.
installation starts with the analogue channels followed by the digital channels. The time taken for installation
depends on the number of channels available. You can stop the first auto installation by pressing the POWER
button on the remote control. The auto installation is stopped and the TV goes into standby mode. Any channels
that have already been found are stored.
Note : This screen will only appear the first time you turn on the TV. If you wish to auto install programs later,
please follow the procedure on the next page (page 9).
Follow the instructions on this screen to start auto installation:
Press
CURSOR
or
Press OK button to confirm and start auto installation.
H
ELPFUL
ANTENNA : If you have an off-air or roof-top
antenna, select Antenna.
CABLE : If you have subscribed to cable signal from
any cable company, or you are receiving free-to-air
cable channels through your wall connection select
Cable.
The first-time installation will install both Digital
and Analog channe ls.
FIRST TIME YOU TURN ON THE TV
VIRGIN MODE
Please connect Antenna or
Cable to TV.
Select TV signal by
or
arrow key and press ok
Signal Type
Antenna
Press OK to launch the Auto
Channel Search.
AUTO CHANNEL SEARCH
Go Back
Signal Type
Antenna
Start
Running
Analog Channel
69
Search percent
83
Digital Channel
4
Installation may take about
30 min.
to select Antenna or Cable.
H
INTS
OK
8
Auto