Joystick Control - Swann SWPRO-1080FLB Instruction Manual

Joystick Control

This camera has a joystick control on the cable connection to allow you
to configure the camera settings to suit your DVR signal. The joystick is
a simple 4 way stick configuration (up and down are noted on the fascia)
and pressing in on the top of the stick is used to open the on-screen menu
and as the 'Enter' key while in the OSD menu.
The first use of the joystick is to set the correct output signal mode of the
camera to correspond with the type of recorder you are using. The signal
is changed by holding for approximately 2 seconds in the direction corre-
UP
sponding to the signal you wish to select. The camera signal will shut off
briefly then the camera will restart the signal in the new mode.
NB: If you select the wrong signal type you may see only a Black & White
image, scrambled lines or nothing at all. If this happens, choose the cor-
rect signal type for your device by holding the stick as shown below.
Up – 960H
This is the analog output used with all analog signal (CVBS or Composite)
recorders such as Swann's 3425 and 4200 models.
Down – CVI
This is a 3rd party signal type used by other companies. Swann does not
support the use of this signal type.
Left – AHD
This is the AHD signal used with Swann recorders such as the 4600.
Right – TVI
This is the signal used with Swann recorders similar to the 4500, 4550,
4750 & 8075. This mode supports DVR control over the video cable.
2