Service And Adjustments - Weed Eater WE20VH Instruction Manual

SPOOL REMOVAL
1. Remove battery from trimmer.
2. Invert string trimmer to access spool.
3. Remove spool cover. Press on the two
tabs parallel to each other on the side of
the cover (2).
4. Remove the spool from spool housing
(3).
SPOOL REPLACEMENT
1. Replace the spool (1) with a new pre-
wound spool.
2. Insert the end of line through the opening
(4) in the spool housing (3).
3. Align the tabs on the spool cover with the
slots in the spool housing on the trimmer
head.
4. Push down on the spool cover, locking it
to the spool housing.
5. To advance the line when initially
installed, you must pull the line while
pressing the line release button on the
side of the spool housing (3).
LINE REPLACEMENT
1. Cut the length of line to 20 ft (6m) total
length.
2. Bend one end of the Line 1/4 of an inch
(6.4mm).

SERVICE AND ADJUSTMENTS

2
1
4
3
20 ft
6 m
3. Take the end of the line that is bent 1/4
of an inch (6.4mm) and stick it in the
hole in the spool head.
4. Once the 1/4 of the line is inserted in to
the hole, wind the spool line clockwise
evenly and overlapping the first row and
continuing the process until complete.
5. Once complete the last layer of line
should be evenly wounded. To keep the
line from unraveling hook the line as
shown below.
STORAGE
• Ensure the battery is removed from the
string trimmer.
• Wipe any debris off of the string trimmer.
• Store in a dry cool place out of the reach
of children.
• Position unit so that any sharp object
cannot accidentally cause injury.
14