Related Manuals for Fisher & Paykel WB60S SERIES
Summary of Contents for Fisher & Paykel WB60S SERIES
- Page 1 INSTALLATION INSTRUCTIONS Warming Drawer WB60S models NZ AU GB IE www.fisherpaykel.com 590513E 05.16...
-
Page 2: Safety And Warnings
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS! WARNING! Electrical Shock Hazard To reduce the risk of fire, electrical Before carrying out any work on the ● ● shock, injury to person, or damage electrical section of the appliance, when using the warming drawer, it must be disconnected from the please read these instructions mains electricity supply. - Page 3 SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS! When installing companion products ● ● the weight of the companion product should be distributed across the edges The electrical outlet should be easily of the warming drawer. Products ● ● accessible after installation. above which rest on “feet”...
-
Page 4: Parts Supplied
PARTS SUPPLIED Screws (4) Anti-tip bracket (1) Oven support brackets (2) PRIOR TO INSTALLATION The cavity is square and level, and of the required dimensions. ● ● The installation will comply with all clearance requirements and applicable standards and regulations. ●... -
Page 5: Product Dimensions
PRODUCT DIMENSIONS FRONT SIDE Terminal Block PRODUCT DIMENSIONS Overall height of product Overall width of product Depth of drawer front panel (excluding handle) Depth of chassis (including terminal block) Width of chassis at rear Height from bottom drawer panel to bottom of chassis at rear PLAN Height from bottom of drawer panel to top of chassis Depth of drawer... - Page 6 THE FOLLOWING PAGES DETAIL COMMON CABINETRY SCENARIOS CABINETRY DIMENSIONS - UNDERBENCH (IE INSTALLED WITH A F&P 60CM WIDE SINGLE OVEN) Oven support Oven brackets 720mm Oven Warming Drawer PLAN Warming Drawer Fit the supplied oven support brackets SIDE Unscrew-fit- rescrew CABINETRY DIMENSIONS Oven support bracket Minimum inside height of cavity (with F&P 60cm wide single oven)
- Page 7 CABINETRY DIMENSIONS - WALL MOUNTED (IE INSTALLED WITH A F&P COMPACT OVEN) Compact Oven Warming Drawer Compact Oven 600mm PLAN SIDE Warming Drawer Compact oven Lower trim kit (optional, supplied separately) Warming Drawer IMPORTANT! Additional 18 mm Wood Spacer In a wall mounted installation, there needs to be an 18 mm Cabinet below Spacer fixed underneath the...
- Page 8 CABINETRY DIMENSIONS - WALL MOUNTED (IE INSTALLED WITH A F&P COFFEE MAKER) IMPORTANT! If installing under the F&P Coffee Maker, ensure there is the 45mm gap at the back of the cabinet and the 200mm toekick cutout required for airflow. Refer to the Coffee Maker Install instructions.
- Page 9 CABINETRY DIMENSIONS - WALL MOUNTED (STANDALONE) Supplied Anti-tip Bracket (screwed to the back wall) IMPORTANT! In a standalone wall mounted installation, you must ensure that the supplied anti-tip bracket is installed unless there is a fixed shelf above acting as an anti-tip obstacle. Fixed shelf Steam Oven Warming Drawer...
- Page 10 DISCARD PACKAGING RESPONSIBLY Unpack the warming drawer and inspect for any signs of damage. Do not install the warming drawer if it has been damaged. IMPORTANT! Packing materials (e.g. plastic bags, polystyrene foam, staples, packing straps etc) and tools should not be left around during and after installation, especially if they are within easy reach of children, as they may cause serious injuries.
- Page 11 SECURE THE WARMING DRAWER TO THE CABINETRY 1 Ensure the warming drawer is level and positioned in place in the cavity. IMPORTANT! Do not lift the warming drawer by the drawer handle. 2 Fully open the drawer. 3 Fasten the warming drawer in place with the two screws supplied, through the front trim, beneath the drawer.
-
Page 12: Final Checklist
FINAL CHECKLIST FP WARMER DRAWER INTERFACE LOGIC_V1 TO BE COMPLETED BY THE INSTALLER Make sure the warming drawer is level and securely fitted to the cabinetry. Make sure any internal packaging has been removed from the drawer. FP WARMER DRAWER INTERFACE LOGIC_V1 PRODUCT OFF USER PRESSES ON/OFF BUTTON Make sure that the isolating switch is accessible by the customer. - Page 16 www.fisherpaykel.com Copyright © Fisher & Paykel Appliances 2016. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available.