Table of Contents
Advertisement
Front-of-house
Cabling for a 16 x 16 system; use either AN-16/i or AN-16/i-M Input Modules
as needed.
To configure a 16 x 16 system:
1.
Set up one Pro16 input module (AN‑16/i or AN‑16/i‑M) and
one AN‑16/o on each side of the network. (For example,
one set is at the front‑of‑house mix position, the matching
set is placed on the stage.)
2.
Connect sixteen mic‑ or line‑level audio sources to inputs
1‑16 on the first Pro16 input module.
3.
Connect a Cat‑5e cable from the A‑Net Out jack on the
first input module to the A‑Net Expansion jack on the first
AN‑16/o.
4.
Plug a Cat‑5e cable into the A‑Net In jack on the first
AN‑16/o Output Module. This cable will be used to span
up to 500 feet/150 meters between the two sides of the
network.
5.
Connect the cable from the A‑Net In jack in Step 4 to the
A‑Net Out jack on the second Pro16 input module.
6.
Connect the second group of sixteen audio sources to
inputs 1‑16 on the second Pro16 input module.
7.
Connect a Cat‑5e cable from the A‑Net Expansion jack on
the second input module to the A‑Net In on the second
AN‑16/o.
8.
Patch the audio outputs from the two AN‑16/o Output
Modules into the desired destinations.
AN-16/
-M M
i
M
i
ic
Nput
odule
Channels 1-16
Channels 17-32
u
G
ser
uide
Stage
31
Advertisement
Table of Contents
