Troubleshooting; Tassimo Careline - Bosch TAS 85xxGB/CH Instruction Manual

en

Troubleshooting

The following table provides solutions for problems and glitches that may arise as you
use your TASSIMO machine. If you do not find a solution for your specific problem, or the
problem persists after troubleshooting please contact our customer service department.
Problem
Appliance not working;
no symbols light up.
I can't read the LC-
display because it is in
the wrong language.
Machine brews but no
drink dispensed.
O
Automatic mode
not working, appliance
remains in stand-by
mode.
O
Automatic mode
skipped, appliance
goes straight to
N
Manual mode.
03_TAS65-85_GB-CH.indb 17
Possible!cause
There is no power supply.
You may want to change the
language setting.
The water tank was removed
during the brewing process or
there is air in the system.
The float in the water tank is
stuck.
Appliance is not switched on.
No T DISC inserted.
The barcode could not be
detected.
The barcode could not be
detected.
Solution
Check that the appliance is
properly plugged into the
power supply.
Please proceed as described
in the section "Controls and
displays".
Replace the water tank in the
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
Clean the water tank and
ensure the float can move.
Make sure the appliance is
switched on before inserting a
T DISC.
Check if T DISC has been
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact the

TASSIMO careline.

Clean the bar code reading
window.
Use another T DISC.
You can still prepare the drink
by holding down the start / stop
button.
17
01/2013
11.01.2013 15:58:47