Mercedes-Benz GLE COUPE Operator's Manual page 200

Hide thumbs Also See for GLE COUPE:
Table of Contents

Advertisement

Driving systems
198
the road is narrow and winding
R
there are highly variable shade conditions on
R
the roadway
no vehicle is detected in the adjacent lane and
R
there are broken lane markings
Warning vibration in the steering wheel
A warning may be given if a front wheel passes
over a lane marking. It will warn you by means of
intermittent vibration in the steering wheel for
up to 1.5 seconds.
In order that you are warned only when neces-
sary and in good time if you cross the lane mark-
ing, the system detects certain conditions and
warns you accordingly.
The warning vibration occurs earlier if:
you approach the outer lane marking on a
R
bend
the road has very wide lanes, e.g. a highway
R
the system detects solid lane markings
R
The warning vibration occurs later if:
the road has narrow lanes
R
you cut the corner on a bend
R
Lane-correcting brake application
G
WARNING
A lane-correcting brake application cannot
always bring the vehicle back into the original
lane. There is a risk of an accident.
Always steer, brake or accelerate yourself,
especially if Active Lane Keeping Assist warns
you or makes a lane-correcting brake appli-
cation.
G
WARNING
Active Lane Keeping Assist does not detect
traffic conditions or road users. In very rare
cases, the system may make an inappropriate
brake application, e.g. after intentionally driv-
ing over a solid lane marking. There is a risk of
an accident.
An inappropriate brake application may be
interrupted at any time if you steer slightly in
the opposite direction. Always make sure that
there is sufficient distance on the side for
other traffic or obstacles.
If you leave your lane, under certain circumstan-
ces the vehicle will brake briefly on one side.
This is meant to assist you in bringing the vehicle
back to the original lane.
If a lane-correcting brake application occurs,
display : appears in the multifunction display.
A lane-correcting brake application can be made
after driving over a lane marking recognized as
being solid or broken. Before this, a warning
must be given by means of intermittent vibration
in the steering wheel. In addition, a lane with
lane markings on both sides must be recog-
nized.
In the case of a broken lane marking being
detected, a lane-correcting brake application
can only be made if a vehicle has been detected
in the adjacent lane. The following vehicles can
have an influence on brake application: oncom-
ing traffic, vehicles that are overtaking and vehi-
cles that are driving parallel to your vehicle.
i
A further lane-correcting brake application
can only occur after your vehicle has returned
to the original lane.
No lane-correcting brake application occurs if:
you clearly and actively steer, brake or accel-
R
erate.
you cut the corner on a sharp bend.
R
you have switched on the turn signal.
R
a driving safety system intervenes, e.g. ESP
R
®
PRE-SAFE
Brake or Active Blind Spot Assist.
you have adopted a sporty driving style with
R
high cornering speeds or high rates of accel-
eration.
®
ESP
is switched off.
R
the transmission is not in position D.
R
on vehicles with a trailer tow hitch, the elec-
R
trical connection to the trailer has been cor-
rectly established.
®
,

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents