Setting Up Sources - Meridian 861 User Manual

CONFIGURING
WITHOUT A

Setting up sources

COMPUTER
This section explains how to use Gain/Sub mode to set up the sources
connected to the digital surround controller, and configure them to suit
your other equipment.
You can also adjust the subwoofer crossover frequency to suit the
subwoofers in your system.
To turn on Gain/Sub mode
• Put the digital surround controller into standby by pressing Off (front
• Press and hold the Config key under the front panel for at least five
The display shows:
The digital surround controller will then return to standby with Gain/Sub
mode turned on.
Gain/Sub mode adds two extra options to the DSP parameter menus:
Sensitivity and Xover.
To turn off Gain/Sub mode
• Repeat the above procedure until
To adjust the sensitivity of a source
To obtain the best signal-to-noise ratio for your analogue sources you can
adjust the sensitivity of each input to give the highest level that does not
produce clipping.
• Turn on Gain/Sub mode, as described above.
• Select the source you want to adjust, with loud source material playing.
• Press < or > (remote or under the front panel) until the display shows
For example:
• Press A or V (remote or under the front panel) to change the sensitivity.
panel or remote).
seconds.
the display shows:
the current sensitivity.
Gain/Sub On
Gain/Sub Off
Radio 2.0V In
61