Adjust the tilt stand
Connect the IR-USB cable
U1273A/U1273AX User's Guide
To adjust the multimeter to a 60° standing position, pull the
tilt- stand outward to its maximum reach.
Pull until maximum reach
Figure 1-6 Tilt-stand adjustment and IR-USB cable connection
You can use the IR communication link (IR communication
port, located at the rear panel) and the Agilent GUI Data
Logger software to control your multimeter remotely,
perform data logging operations, and transfer the contents of
your multimeter's memory to a PC.
Ensure that the Agilent logo on the U1173A IR- USB cable
(purchased separately) connected to the multimeter is facing
up. Firmly push the IR head into the multimeter's IR
communication port until it snaps into place (see
Figure 1-
6).
Introduction
Preparing Your Multimeter
To PC (host)
IR-USB cable
1
11