Connect With Rs232 Serial Port - Honeywell ORBIT 7120PLUS User Manual

Connect with RS232 Serial Port

1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the scanner.
Note: For the scanner to work properly, you must have the correct cable for your type of
terminal/computer.
Note: For RS232, you must use the power supply.
3. Plug the serial connector into the serial port on your computer. Tighten the two
4. Once the scanner has been fully connected, power up the computer.
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.
4
screws to secure the connector to the port.
Orbit 7120plus/7190g User Guide