Front Panels For The Micromaster 420; Table 3-1 Default Settings For Operation Using The Status Display Panel - Siemens Micromaster 420 Operating Instruction

3. COMMISSIONING
3.1

Front Panels for the MICROMASTER 420

Front panels
The front panels shown below are available for use with the MICROMASTER 420
Inverters. The panel on the left is supplied with the inverter as standard and is referred to
as the Status Display Panel (SDP). The Basic Operator Panel (BOP) and Advanced
Operator Panel (AOP) are available as options.
S t a t u s D i s p l a y P a n e l
( S t a n d a r d )
Figure 3-1
Changing the front panel
The procedure for removing the SDP and fitting the BOP or AOP, which are available as
options, is described in Appendix A.
3.1.1 Commissioning with the Status Display Panel (SDP)
Table 3-1
Digital Input 1
Digital Input 2
Digital Input 3
Output Relay
Analogue Output
Analogue input
MICROMASTER 420 Operating Instructions
6SE6400-5AA00-0BP0
150.00
Hz Hz
B a s i c O p e r a t o r P a n e l
Panels available for the MICROMASTER 420 Inverter
The SDP is supplied with your MICROMASTER 420 Inverter as
standard. This panel has two LEDs on the front, which indicate
the operational status of the inverter.
With the SDP the inverter can be used with its default settings,
for many applications. The default settings are shown in Table
3.1
The terminal layout is shown in the photograph of the Control
Terminal Connections on the inside of the back cover of this
manual.
Default settings for operation using the Status Display Panel
Terminals
5
6
7
10/11
12/13
3/4
1/2
Fn
1
0 jog P
( O p t i o n )
Parameter Default Operating
P0701 = '1' ON right
P0702 = '12' Reverse
P0703 = '9' Fault Reset
P0731 = '52.3' Fault Identification
P0771 = 21 Output Frequency
P0700 = 0 Frequency Setpoint
Analog Input supply
International English
R U N N I N G
P 0 0 0 F = 5 0 . 0
H Z
I = 4 . 8 R P M = 1 5 0 0
V = 4 0 0 v
Fn
1
menu
0 jog P
A d v a n c e d O p e r a t o r P a n e l
( O p t i o n )
f n
f l
p
v
29