Wiring Diagram - Apollo BETA ACR-110N Instruction Manual

ENG

WIRING DIAGRAM

Switch off the car audio system prior to connect the speakers.
During the installation, use speakers with an impedance of 4 – 8 ohms.
Do not connect the speaker terminals to the car's coachwork.
Do not connect the ground wire (battery cathode) of the car audio system to the speaker
terminal (-).
Do not connect speakers in parallel.
Connect only passive speakers. Active speakers connected to the speaker terminals (with built-
in amplifiers) may damage the car audio system.
Do not connect speaker wires to each other.
If the red wire is connected to the power (battery positive pole), memory circuit will be powered
continuously, even after the ignition is switched off.
6