Troubleshooting; Common Problems; Imaging Problems - Philips 225P1 User Manual

Troubleshooting

Safety and
Troubleshooting
FAQs

Common Problems

Imaging Problems

Regulatory Information
file:///E|/LCD%20Monitor%20OEM/Philips/M1-project/225B1/225B1-EDFU/5B...-new-format/CD-Contents/lcd/manual/ENGLISH/225B1/safety/
Troubleshooting
This page deals with problems that can be corrected by a user. If the problem still persists after you have tried these
solutions, contact Philips customer service representative.
Common Problems
Having this problem
No Picture
(Power LED not lit)
No Picture
(Power LED is white blinking)
Screen says
AUTO button doesn't function in VGA
mode
Imaging Problems
Image is not centered
Check these items
Make sure the power cord is plugged into the power outlet
●
and into the back of the monitor.
First, ensure that the power button on the front of the monitor
●
is in the OFF position, then press it to the ON position.
Make sure the computer is turned on.
●
Make sure the signal cable is properly connected to your
●
computer.
make sure the monitor cable has no bent pins on the connect
●
side. If yes, repair or replace the cable.
The Energy Saving feature may be activated
●
Make sure the monitor cable is properly connected to your
●
computer. (Also refer to the Quick Set-Up Guide).
Check to see if the monitor cable has bent pins.
●
Make sure the computer is turned on.
●
The auto function is applicable only in VGA-Analog mode. If
●
the result is not satisfactory, you can do manual adjustments
via the OSD menu. Note that the Auto Function is not
applicable in DVI-Digital mode as it is not necessary.
Press the Auto button.
●
Adjust the image position using the Phase/Clock of Setup in
●
OSD Main Controls.
saf_troub.htm 第 1 頁 / 共 3 [98-07-01 15:09]