Samsung OfficeServ500 Installation Manual page 31

4-2 Chapter 4
Installing Processor and Interface Cards
Position
LOC1
LOC2
LOC3
* The ESM must be installed in this position in a multiple cabinet ('L') system or any system running 'L' version software
NOTE: Only one of any given type of daughterboard may be installed on any one MCP2
card (e.g. only one MFM can be installed on one card).
Auto Program Download Enable
Switches 1—4 select the country in which the system is installed.
Country
UK
Italy
Australia
Holland
Denmark
New Zealand
Korea
USA
Switch 5 selects if Auto Program Download (APD) is enabled. If enabled (ON), a check is
made on the current system software version: if it does not match the SmartMedia card
software version, the SmartMedia version is downloaded to the system.
These DIP switches will not take effect unless set in the required positions and the system
memory is cleared manually using the Memory Backup switch.
MAIN CONTROL PROCESSOR CARD DAUGHTERBOARDS
Type of Daughterboard Allowed
MFM, SCM, RCM and ESM*
MFM, SCM, RCM
MFM, SCM, RCM and MISC
DIP Switches on the MCP2 Card
ON (left)
Country Select
Country Select
Country Select
Country Select
4 Digit Station Numbers
4 Digit Station Groups
4 Digit Trunk Numbers
1
OFF
ON
OFF
OFF
ON
ON
OFF
ON
OFF (right)
SW1 Country Select
SW2 Country Select
SW3 Country Select
SW4 Country Select
SW5 Auto Program Download Disable
SW6 3 Digit Station Numbers
SW7 3 Digit Station Groups
SW8 3 Digit Trunk Numbers
2 3
ON OFF
ON OFF
OFF ON
ON ON
ON ON
OFF ON
OFF OFF
OFF OFF
4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF