Troubleshooting - Philips BRILLIANCE 200P3M User Manual

Troubleshooting

Troubleshooting
Safety and Troubleshooting
Information • Other Related Information
This page presents problems that can be corrected by the user. If the problem still exists after these possible
solutions, contact your nearest Philips dealer.
Common Problems
Having this problem?
No Picture
(Power LED not lit)
No Picture
(Power LED is amber or yellow)
Screen says
AUTO button not working properly
Imaging Problems
Display position is incorrect
Image vibrates on the screen
file:///D|/K1/english/200p3mg/safety/saf_troub.htm (1 of 2) [1/3/2003 3:34:53 PM]
• FAQs • Common Problems
Check these items
• Imaging Problems
Make sure the Power cable is plugged to the wall
and the back of the monitor.
First, power button in front of the monitor should
be in the OFF position, then press it to ON
position again.
Make sure the computer is turned on.
Make sure the signal cable is properly connected
to your computer.
Check to see if the monitor cable has bent pins.
The Energy Saving feature may be activated
Make sure the monitor cable is properly
connected to your computer. (Also refer to the
Quick Set Up Guide).
Check to see if the monitor cable has bent pins.
Make sure the computer is turned on.
The Auto Function is designed for use on
standard Macintosh or IBM-compatible PC
running Microsoft properly Windows.
It may not work properly if using nonstandard PCs
or video card.
Push the Auto button.
Adjust the image position using the Horizontal
Position &/or Vertical Position in OSD Main
Controls.
Check that the signal cable is properly connected
to the graphics board or PC.
• Regulatory