Cisco SpeakerTrack 60 Installation Manual page 9

Mount the cables
Connect the cables to the connector panel on the base unit:
1. Find the Ethernet cables (I, J) and the power cables (G, H) in the accessories box.
Connect the short cables to the connectors marked R (
connectors marked L (
camera mounting.
2. Connect the microphone cables coming from the microphone panel.
3. Find the power adapter and the power cable (K) in the accessories box. Connect the
power cable to the base unit.
4. Connect an Ethernet cable (not included) to the Ethernet port on the base unit. Connect
the other end directly to the codec. If you do not have any free Ethernet port on the
codec (typically if a Touch device is connected) you will need a network switch. Connect
the switch to the Ethernet port on the codec, and connect the Touch device and
SpeakerTrack 60 to the switch. We recommend using a Cisco switch.
Connect the short Ethernet and
1
power cables to the right camera,
and the long Ethernet and power
cables to the left camera.
Connect the
3
power cable.
Rear view
). Lead them through the open slot to make them available for
) and the long cables to the
Connect the microphone
2
cables that comes from
the microphone panel.
Connect the Ethernet
4
cable (not included)
directly to the codec
(Eth2/Eth3).