JVC LT-26WX84 Service Manual page 13

3.1.3 REMOVING THE FAN BRACKET / REGULATOR PWB / POWER CORD
• Remove the STAND.
• Remove the REAR COVER.
(1) Pull out the wire of COOLING FAN (the connector [Y] of the
POWER PWB).
(2) Remove the 5 screws [F], and remove the FAN BRACKET.
(3) Remove the REGULATOR PWB.
(4) Pull out the POWER CORD.
(5) Remove 1 screw [G], and remove the POWER CORD
HOLDER.
3.1.4 REMOVING THE RECEIVER PWB
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 3 screws [H] and 3 screws [J] (6 screws in
total). Then, remove the TERMINAL BASE.
(2) Remove the 6 screws [K], and remove the RECEIVER
PWB.
3.1.5 REMOVING THE FRONT CONTROL PWB CONTROL / FRONT SENSOR PWB
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 2 screws [L], and remove the CONTROL
KNOB.
(2) Remove the 3 screws [M], and remove the FRONT
CONTROL PWB.
(3) Remove the FRONT SENSOR PWB.
F
FAN BRACKET
COOLING
FAN
REGULATOR
PWB
G
G
Fig.3-1-3
TERMINAL BASE
K
H
RECEIVER PWB
K
J
Fig.3-1-4
EARTH
M
FRONT CONTROL PWB
PLATE
L
FRONT SENSOR PWB
T
U
KNOB
CLAMP
HARNES( F,U,T),"S" WIRE
F
Fig.3-1-5
F
POWER CORD
G
POWER CORD HOLDER
T
(No.YA003)1-13