Installing the Keyboard
1
Adhere the Mylar to the keyboard.
2
Align the screw holes on the keyboard with the screw holes on the palm-rest assembly.
3
Replace the 31 M1.6 x 1.5 screws that secure the keyboard to the palm-rest assembly.
4
Adhere the Mylar to the screws that secure the keyboard to the palm-rest assembly.
5
Connect the keyboard cable and keyboard-backlight cable to the keyboard-controls board.
6
Install the:
a
system board
b hard drive
c
base cover
7
Follow the procedures in After Working Inside Your Computer.
WLAN card
Removing the WLAN Card
1
Follow the procedures in
2
Remove the:
a
Base cover
b
battery
3
Perform the following steps to remove the WLAN card:
a
Remove the screw to release the bracket that secures the WLAN card to the computer [1] and lift the bracket away from the
computer [2].
b Disconnect the antenna cables from the WLAN card [3].
c
Slide and remove the WLAN card from its connector on the board [4].
16
Removing and installing components
Before Working Inside Your
Computer.