Installing A Raid Adapter Battery Or Flash Power Module Remotely In The Server - Lenovo System x3500 M4 Installation And Service Manual

Step 2. Locate the ServeRAID adapter which you will install the memory module. Remove the ServeRAID
adapter if necessary.
Step 3. Touch the static-protective package that contains the memory card to any unpainted metal surface
on the server; then, remove the memory card from the package.
Step 4. Align the memory module with the connector on the ServeRAID adapter and push it into the
connector until it is firmly seated.
Figure 51. Align the memory module
If you have other devices to install or remove, do so now.
Installing a RAID adapter battery or flash power module remotely in
the server
Use this information to install a RAID adapter battery or flash power module remotely in the server.
Note: When you install any RAID adapter that comes with batteries, it is sometimes necessary to install the
batteries in another location in the server to prevent the batteries from overheating.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 35.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install a RAID adapter battery or flash power module remotely in the server, complete the following steps.
Step 1. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 40).
Step 2. Install the ServeRAID adapter on the system board (see "Installing an adapter" on page 216).
Step 3. Connect one end of the battery/flash power module cable to the battery/flash power module
connector.
Step 4. Route the remote battery/flash power module cable as shown in the following illustration.
.
Chapter 2 Installing optional devices
75